Archgard Optima 45 - 3 Especificações

USERS’ INSTALLATION OPERATION and MAINTENANCE MANUAL 4545--DVFS28NDVFS28N--22 Optima 45Optima 45 SN 5170 AND UPSN 5170 AND UP For use with Natural

45-DVFS28N-2 10 LOCATING GAS HEATER This appliance must be installed in a location that is free of plumbing, electrical

45-DVFS28N-2 11 ALLOWABLE TERMINATION LOCATIONS Canadian Installations (1) US Installations (2) Canadian Installations (1) US

45-DVFS28N-2 12 APPROVED VENT COMPONENTS For best and safe venting performance, here are some general venting rules:  Use only Arc

45-DVFS28N-2 13 VENTING CHART The appliance will not function without being connected to a proper venting system. This appliance may

45-DVFS28N-2 14 1. Maintain 1” (25 mm) clearance (air space) to combustibles when passing through ceilings walls, roof, enclosures

45-DVFS28N-2 15 NOTE:  Galvanized pipe is desirable above the roofline due to its higher corrosion resistance. Continu

45-DVFS28N-2 16 NOTES: This Vent Kit must be installed directly onto the flue outlet of the heater. Maintain a minimum of 1” (25m

45-DVFS28N-2 17 VENTING - BELOW GRADE USING FLEXIBLE DIRECT VENT SYSTEMS INSTALLATION PROCEDURES FOR ARCHGARD SNORKEL KIT (999-DV-STC

45-DVFS28N-2 18 Measure wall thickness from the back of the fireplace standoffs to inside mounting surface of the termination cap. If

45-DVFS28N-2 19 VENTING - HORIZONTALLY USING SIMPSON DURA-VENT DIRECT VENT SYSTEMS 1. Set the Optima 45 in its desired locati

5.08: Modifications to NFPA-54, Chapter 10 (2) Revise 10.8.3 by adding the following additional requirements: (a) For all side wall horizontally vent

45-DVFS28N-2 20 VENTING - HORIZONTALLY USING SIMPSON DURA-VENT DIRECT VENT SYSTEMS INSTALLATION PROCEDURES FOR SIMPSON DURA-VENT DIRE

45-DVFS28N-2 21 SNORKEL TERMINATIONS: For installations requiring a vertical rise on the exterior of the building, 14” (3

45-DVFS28N-2 22 LOG PLACEMENT Archgard chooses ceramic fiber logs for use in the Optima 45. The logs are designed to give a re-alis

45-DVFS28N-2 23 LOG PLACEMENT - Continued LOG 74 BACK LOG RESTS REAR LOG RESTS The rear logs must be placed on top of the log rests

45-DVFS28N-2 24 LOG PLACEMENT - Continued LOG #1 Place log number 1 on top of the left rear log rest with the two pins aligned with

45-DVFS28N-2 25 LOG PLACEMENT - Continued LOG #3 LOG #4 Place log number 3 on the two right pins so they align with the holes in the

45-DVFS28N-2 26 LOG PLACEMENT - Continued LOG #5 Place log number 5 so the bottom left of the log sits on the burner directly behind

45-DVFS28N-2 27 The Optima 45 has optional Ceramic Brick Panels or Reflective Glass Panels available. They can be purchased through

45-DVFS28N-2 28 If a wall-mounted switch or a wall-mounted thermostat is desired, Archgard recommends that the device be wired as sho

45-DVFS28N-2 29 INITIAL OPERATION 1. Check that the appliance is properly vented and connected to the gas supply. 2. Check that the

INTRODUCTION Congratulations on choosing an Archgard fireplace! The Optima 45 is one of the most advanced direct vent fireplace heaters available. It

45-DVFS28N-2 30 This appliance has a pilot which must be ignited using the sparker located next to the appliance valve controls. When

45-DVFS28N-2 31 1. Set the thermostat to the lowest setting and turn the remote switch to “OFF”. 2. Turn off all electric power to

45-DVFS28N-2 32 WARNING: Do not attempt to remove the glass door when the appliance is hot. Removing the Glass Door 1. Open both sid

45-DVFS28N-2 33 TROUBLESHOOTING SYMPTOM ACTION Pilot will not light after pressing the sparker many times. 1. When lighting the appl

45-DVFS28N-2 34 TROUBLESHOOTING Continued SYMPTOM ACTION The main burner does not turn on with the pilot lit. Cont... 3. Check to ma

45-DVFS28N-2 35 Regularly:  Frequent cleaning of the ceramic glass is required. Archgard recommends using a good quality “gas fire

45-DVFS28N-2 36 Before servicing, read the Terms and Conditions of the Archgard Warranty at the back of the manual. Contact the Autho

45-DVFS28N-2 37 ADJUSTING PRIMARY AIR 1. Remove the glass door. Follow GLASS DOOR REMOVAL instructions within this manua

45-DVFS28N-2 38 Thermopile Burner Ports Electrode Thermocouple 1. Remove the control panel. 2. The pressure test taps are located on

45-DVFS28N-2 39 REPLACING CONVECTION BLOWER Caution: Label all wires prior to disconnection when servicing controls. Wiring

TABLE OF CONTENTS Caution and Safety Instructions 5 Appliance Certification / Installation Codes / Specifications / High Altitude Installation 6 Gas C

45-DVFS28N-2 40 VALVE TRAY ASSEMBLY Item # Item Description Qty Unit A 308-0013 Valve NOVA SIT 820 (0.820.652) Natural Gas

45-DVFS28N-2 41 PARTS LIST - Ceramic Logs and Burner Pan Item # Item Description Qty Unit 310-6450-1 FiberFlame Log #1 1 EA 310

45-DVFS28N-2 42 REPLACEMENT PARTS LIST ARCHGARD OPTIMA 45-3 Item # Item Description Qty Unit 200-0185 Owner’s Manual 1 EA 300-0

This Limited Warranty is made by ARCHGARD INDUSTRIES LTD., hereinafter referred to as “Archgard”. Archgard warrants to the original purchaser of an

45-DVFS28N-2 44 FREQUENTLY ASKED QUESTIONS Listed below are some frequently asked questions regarding your Archgard Gas Fireplace. If

45-DVFS28N-2 45 NOTES

POSTAGFOLD DOWN AT LINE FOLD DOWN AT LINE & TAPE CLOSED CUT ALONG LINE CUT ALONG LINE CUT ALONG LINE WARRANTY REGISTRATION ARCHGARD INDUSTRIES LT

Archgard Industries Ltd. 7116 Beatty Drive Mission, B.C. V2V 6B4 Canada Website: www.archgard.com

45-DVFS28N-2 5 CAUTION FOR YOUR SAFETY - Do not install or operate your Archgard Optima 45 Direct Vent Gas Fireplace

45-DVFS28N-2 6 SPECIFICATIONS Natural Gas (NG) Propane (LP) Manifold Pressure 1.6 - 3.5 in. W.C. (0.4 - 0.9 kPa) 6.3 - 10.0 in. W.

45-DVFS28N-2 7 Before connecting the appliance to the gas supply line, double check that the appliance you have purchased is

45-DVFS28N-2 8 APPLIANCE DIMENSIONS APPLIANCE DESCRIPTION MAIN CONTROL PANEL UPPER LOUVERS GLASS DOOR LOWER LOUVERS DIMENSIONS A

45-DVFS28N-2 9 DIMENSIONS AND CLEARANCES ALCOVE INSTALLATION * Side and back clearances for the alcove installation is the same as t