USERS’ INSTALLATION OPERATION and MAINTENANCE MANUAL 200-1908 November 2009 WARNING: If the information in this manual is not followed exactly, fire
Optima 40 - SB 10 LEVELING THE OPTIMA 40-SB DIRECT VENT INSERT Before placing the appliance into the fireplace,
Optima 40 - SB 11 The Optima 40-SB Requires two flexible gas flue liners: Flue Collar (inlet) 3” (76 mm) dia
Optima 40 - SB 12 Instructions for use with Archgard vertical termination cap. Part # 999-INS-TK. Install the t
Optima 40 - SB 13 SURROUND INSTALLATION Make sure the gas and electrical lines are properly connected to the a
Optima 40 - SB 14 If a wall-mounted switch or a wall-mounted thermostat is desired, Archgard recommends that the
Optima 40 - SB 15 LOG PLACEMENT WARNING Failure to position the parts in accordance with these diagrams or fai
Optima 40 - SB 16 Step 2. Locate log #2 and place it on the left side of burner, aligning the pins on the burner
Optima 40 - SB 17 LOG PLACEMENT - Continued Step 3. Locate log #3 and place it on the left side of burner, align
Optima 40 - SB 18 LOG PLACEMENT - Continued Step 5. Locate log #5 and place it on the burner as shown. Step 6. L
Optima 40 - SB 19 LOG PLACEMENT - Continued Step 7 Locate Embers (Part #310-0019) and place as shown. IMPORTANT:
5.08: Modifications to NFPA-54, Chapter 10 (2) Revise 10.8.3 by adding the following additional requirements: (a) For all side wall horizontally vent
Optima 40 - SB 20 LOG PLACEMENT - Continued The Optima 40-SBN has optional brick and glass panels and must
Optima 40 - SB 21 BRICK PLACEMENT Continued Right Brick Panel Placement as Shown
Optima 40 - SB 22 Left Brick Panel Placement as Shown NOTE: Installing the panels in any other position other t
Optima 40 - SB 23 INITIAL OPERATION 1. Check that the appliance is properly vented and connected to the gas sup
Optima 40 - SB 24 This appliance has a pilot which must be ignited using the sparker located next to the applian
Optima 40 - SB 25 1. Set the thermostat to the lowest setting and turn the remote switch to “OFF”. 2. Turn off
Optima 40 - SB 26 GLASS DOOR REMOVAL 1. Remove the TOP louver by pulling the entire louver assembly towards you
Optima 40 - SB 27 OPTIONAL BAY DOOR INSTALLATION CAUTION: Only trim kit (s) supplied by the manufacturer may be
Optima 40 - SB 28 TROUBLESHOOTING SYMPTOM ACTION Pilot will not light after pressing the sparker many times. 1.
Optima 40 - SB 29 TROUBLESHOOTING SYMPTOM ACTION The main burner does not turn on with the pilot lit. Cont... 3
Congratulations on choosing an Archgard Gas Fireplace! The 40-DVI40N Direct Vent Insert is one of the most advanced Direct Vent Insert
Optima 40 - SB 30 CAUTION Do not conduct maintenance on the appliance while it is operating or while it is still
Optima 40 - SB 31 Before servicing, read the terms and conditions of the Archgard warranty at the ba
Optima 40 - SB 32 ADJUSTING PRIMARY AIR NOTE: Fig. 1 Is to give an example of what a correct or incorrect flame
Optima 40 - SB 33 1. Open the lower grills. 2. The pressure test taps are located on the valve. The taps are l
Optima 40 - SB 34 REPLACING CONVECTION BLOWER CAUTION: Label all wires prior to disconnection when servi
Optima 40 - SB 35 VALVE TRAY ASSEMBLY Item # Item Description Qty Unit A 308-0043 Valve, ROBERTSHAW, Hi
Optima 40 - SB 36 PARTS LIST - LOGS AND BURNER Item # Item Description Qty Unit 310-6400-1 Premium Log # 1
Optima 40 - SB 37 REPLACEMENT PARTS LIST Item # Item Description Qty Unit 200-0219 Owner’s Manual 1 EA 84
Optima 40 - SB 38 Item # Item Description Qty Unit Replacement parts for 40-DBAY Bay Door (Option) 300-
This Limited Warranty is made by ARCHGARD INDUSTRIES LTD., hereinafter referred to as “Archgard”. Archgard warrants to the original purchaser of an
PAGE Caution and Safety Instructions 5 Appliance Certification / Installation Codes / Specifications / High Altitude 6 Appliance Dimensions / Minim
Optima 40 - SB 40 FREQUENTLY ASKED QUESTIONS Listed below are some frequently asked questions regarding your Arc
Optima 40 - SB 41 NOTES
POSTAGE WARRANTY REGISTRATION ARCHGARD INDUSTRIES LTD. 7116 BEATTY DRIVE MISSION, B.C. CANADA V2V 6B4 FOLD DOWN AT LINE FOLD DOWN AT LINE & TAPE
Archgard Industries Ltd. 7116 Beatty Drive Mission, B.C. V2V 6B4 Canada Website: www.archgard.com
Optima 40 - SB 5 Due to high temperatures, the appliance should be located out of traffic and away from furnitur
Optima 40 - SB 6 This appliance is tested and certified to the following USA and Canadian gas appliance standard
Optima 40 - SB 7 MINIMUM FIREPLACE DIMENSIONS J SIDE VIEW L M K APPLIANCE DIMENSIONS H DIMENSIONS A 28” (
Optima 40 - SB 8 CLEARANCES TO COMBUSTIBLES CAUTION: This appliance is designed for used in any masonry or facto
Optima 40 - SB 9 Before connecting the appliance to the gas supply line, double check that the applia
Comentários a estes Manuais